TPG A776 Printer with Imaging, Руководство пользователя

Страница: 23 / 52

18
Chapter 3: Settng up the Printer
A776 Two-Color Thermal/Impact Hybrid Printer: User Guide A776 UG00001 B 10/06
Ethernet communication connector panel
Ethernet
connector
Power
supply
connector
If installing the Ethernet communication cable:
You don’t need to turn off the computer. Plug the
printer end of the Ethernet cable into the Ethernet
connector port on the printer (A). Make sure the
connector snaps firmly in place.
Plug the computer end of the Ethernet cable into
the Ethernet port of the computer. Make sure the
connector snaps firmly in place. 1.
2.
After you have connected the printer, you may need
to set the printer internal parameters for Ethernet
operation. See “Ethernet Terminology and Setup”
section of the A776 Programming Guide. 3.
Power supply cable
Plug the power cord into the back of the printer.
Route the cash drawer and power supply cables
through the strain relief tab on the back of the
printer as shown under “Cable routing” on page 22. 1.
2.
WARNING
Using this device without a grounded outlet is a safety
hazard and voids the printer Warranty, Safety, FCC and
CE Mark designation.
Plug the power cord into the power supply, then
plug the power supply into an outlet. The green
light on the top cover will light up. 3.
CAUTION
To avoid damage to the printer, connect the power
supply cable last.