Federal Communications Commission (FCC) Radio Frequency Interference Statement Warning
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Information to the User
This equipment must be installed and used in strict accordance with the manufacturer’s instructions. However, there is no
guarantee that interference to radio communications will not occur in a particular commercial installation. If this equipment
does cause interference, which can be determined by turning the equipment off and on, the user is encouraged to contact TPG
immediately.
TPG, Inc. is not responsible for any radio or television interference caused by unauthorized modification of this equipment
or the substitution or attachment of connecting cables and equipment other than those specified by TPG. The correction of
interferences caused by such unauthorized modification, substitution or attachment will be the responsibility of the user.
WARNING! In order to ensure compliance with the Product Safety, FCC and CE marking requirements, you must use the power
supply, power cord, and interface cable which are sold for use with this product or which meet the following parameters:
Power Supply
UL
®
Listed (QQGQ), NEC Class 2 power supply with SELV (Secondary Extra Low Voltage), non-energy hazard output, limited
energy source, input rated 100-240 Vac, 1.5/0.8 A, 50/60 Hz, output rated 24 Vdc, 2.3 A for 55-watt unit; 100-200 Vac, 2.0 A,
50/60 Hz, output rated 24 Vdc, 3.125 A for 75-watt unit.
Use of this product with a power supply other than the TPG power supply will require you to test the power supply and TPG
printer for FCC and CE mark certification.
Communication Interface Cable
A shielded (360 degree) interface cable must be used with this product. The shield must be connected to the frame or earth
ground connection or earth ground reference at EACH end of the cable.
Use of a cable other than described here will require that you test the cable with the TPG printer and your system for FCC
and CE mark certification.
Power Cord
A UL
®
listed, detachable 3-wire power cord must be used; where the third wire is the protective earthing conductor. For
applications where the power supply module may be mounted on the floor, a power cord with Type SJT marking must be used.
For applications outside the US, power cords which meet the particular country’s certification and application requirements
should be used.
Use of a power cord other than described here may result in a violation of safety certifications which are in force in the country
of use.
Industry Canada (IC) Radio Frequency Interference Statement
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
Voluntary Control Council for Interference (VCCI) Radio Frequency Interference Statement
This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology
Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs,
the user may be required to take corrective actions.
Disclaimer
Information in this document is subject to change without notice. Consult your TPG sales representative for information that
is applicable and current. TPG reserves the right to improve products as new technology, components, software, and firmware
become available.
No part of this document may be reproduced, translated, or transmitted in any form or by any means, electronic or mechanical,
for any purpose without the express written permission of TPG.
Copyright
© 2005 Transaction Printer Group, Inc. a subsidiary of ATSI Holdings, Inc. All Rights reserved.
Patents Pending. All trademarks or registered trade marks are the property of their respective owners. Printed in USA. Product
specifications subject to change in order to continue meet the needs of the market.
Trademarks
TPG, INC.
™
, ColorPOS
®
, and LogoEZ
®
are trademarks of TPG, Inc., ATSI and its subsidiaries.
Microsoft and Windows NT are registered Trademarks of Microsoft Corporation in the U.S.A. and/or other countries.
Inside Out Networks, Inside Out, EPIC, and Edgeport are trademarks of Inside Out Networks.
All other trademarks and registered trademarks are the property of their respective holders.
Patents:
Made under one or more of the following U. S. patents: 4886381, 5579043, 5613787, 5651624, 5713678, 5752779, 5789916,
5800080, 5879090, 5887999, 5975776, 6027266, 6085973, 6089450, 6129465, 6155483, 6404452, 6486902, 6504331, 5749277,
6722754, 6739773, 6784909.
Web Site
http://www.tpgprinters.com
Содержание A776 Printer with Imaging
Страница 52: ...A776 UG00001 B 10 06...
