Quick Start Guide
*Images may differ from actual products.
Appearance
*The camera’s standard power supply is 12V DC (14W) or PoE (802.3af/at).
Power Supply Interface
(12V DC)
5
Status LED
6
7
Built-in Microphone
2
RJ45 Network Interface
(supports PoE)*
Infrared LED
3
White LED
4
1
1
2
3
4
5
Package Contents
Network Camera
Waterproof Cable
Attachments
Quick Start Guide
Quick
Start
Guide
Option 1: Wall/Ceiling Mounting
1. Stick the mounting template to the desired mounting place. Drill 4 screw holes
according to the template.
2. Insert the anchors into the holes, use the provided screws to fix the camera’s
bracket to the wall or ceiling.
Installing Waterproof Cable Attachments
Wall Mounting
Install the waterproof cable attachments for the network interface when the camera is installed outdoors.
Note: Make sure each part is securely attached and the waterproof rings are flush to keep out water.
1. Route the network cable through the following components in order: fix nut,
waterproof ring, and then the waterproof jacket.
2. Fix the O-ring to the network interface of the camera and connect the network
cables.
1
Mount Camera
Fix Nut Waterproof
Ring
O-ring
Network
Interface
Waterproof
Jacket
OR
Mounting Template
Anchor
Self-tapping Screw
Anchor
Self-tapping Screw
Mounting Template
Option 2: Pole Mounting
1. Thread each of the two cable ties through the slits on the back of the camera’s
bracket indicated below.
2. Slip the two cable ties through the pole. Tighten them to firmly attach the pole.
Cable Tie
Cable Tie
6
Status LED Indication
Blinking Red Slowly
Blinking Red Quickly
Blinking Green Quickly
Solid Green
Solid Red
Starting up
Disconnecting from the internet
Working normally and connecting to the internet.
Camera upgrading
Camera resetting
7
Speaker
8
Micro SD Card Slot
Insert a micro SD card for local storage. Initialize the SD card via VIGI app before
recording videos.
9
Reset Button
Long press the button to reset the camera to factory settings.
8
9
Note:
Before inserting the micro SD card or resetting
the camera, rotate the sphere and unfasten the two
fixed screws to remove the cover.
3. Attach the network interface with the waterproof jacket, then twist to lock.
4. Insert the waterproof ring into the waterproof jacket. Rotate the fix nut to secure
it to the waterproof jacket.
Mounting Template
Anchors x 4
Screws x 4
©2022 TP
-Link 7106509846 RE
V2.0.0
Note: Make sure that the wall is strong enough to withstand 3 times the
weight of the camera and mounting bracket .
