Wireless Controller
03
Introduction
■
Rear Panel
The rear panel of AC500 is shown as the following figure.
Figure 1-3 Rear Panel of AC500
100-240V
～
50/60Hz 0.5A
Power
Socket
Grounding
Terminal
Grounding Terminal
The wireless controller already comes with lightning protection mechanism. You
can also ground the controller through the PE (Protecting Earth) cable of alternating
current cord or with Ground Cable. For detailed information, please refer to Chapter
3 Lightning Protection.
Power Socket
Connect the female connector of the power cord here, and the male connector to
the AC (Alternating Current) power outlet. Please make sure the voltage of the power
supply meets the requirement of the input voltage.
Caution:
Please use the provided power cord.
The rear panel of AC50 is shown as the following figure.
Figure 1-4 Rear Panel of AC50
Power
Socket
10/100Mbps
RJ45 Port
Power Socket
Connect the female connector of the power cord here, and the male connector to
the AC (Alternating Current) power outlet. Please make sure the voltage of the power
supply meets the requirement of the input voltage.
Caution:
Please use the provided power cord.
Reset
Use the button to restore the wireless controller to the factory defaults. With the
device powered on, use a pin to press and hold the Reset button (more than 5
