!
F: The required tempe-
rature on the left, the
measured temperature
on the right.
E: When the 4-digit
stops blinking, the set-
ting has been locked to
the indicated value.
6
Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C
SETTING THE CLOCK
It is only possible to set the correct time, when the heater is connected to the
MAINSANDNOTBURNING5SETHEADJUSTMENTKEYS
TOSETTHETIME&IRSTPRESS
EITHEROFTHETWOKEYSTOSWITCHONTHEFUNCTIONTHEDIGIT
will start blinking).
Next, set the hours using the key on the left (
쑼
hour) and the minutes using the
key on the right (
쑿
MIN 0RESSONCETOINCREASETHEVALUEBYONESTEP7HENYOU
hold down the key, the value will continue going up, until you release the key
AGAIN!FTERAPPROXIMATELYSECONDSTHEDIGITWILLSTOPBLINKINGANDTHESET
ting will be locked. 5 minutes after switching off the heater, the information on
THEDISPLAYWILLDISAPPEARANDTHEHEATERWILLAUTOMATICALLYSWITCHINTOTHESTAND
by position.
When the heater has been unplugged (or after a power failure), the time needs
to be set again.
D
IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
!LWAYS IGNITE THE HEATER WITH THE
button
. Never use matches or a
cigarette lighter.
Just press the button
TOIGNITETHEHEATER4HE0/7%2LAMPWILLSTARTBLINKING
indicating that the ignition procedure has started. This will take a short while.
/NCETHEHEATERISBURNINGTHE0/7%2LAMPWILLREMAINLITRED 4HEINFORMATION
display
will show two numbers. The light next to them indicates that these
NUMBERSREFERTOTHETEMPERATURES&IG& 4HEACTUALROOMTEMPERATUREIS
INDICATEDBELOW2//-WHILETHETEMPERATURESETTINGISINDICATEDBELOW3%44HE
latter can be changed with the adjustment keys
(refer to Section E).
0RIORTOIGNITINGTHEHEATERALWAYSCHECKFORSUFFICIENTFUELINTHEREMOVABLETANK
E
SETTING THE REQUIRED TEMPERATURE
4HETEMPERATURESETTINGCANONLYBEADJUSTEDWHENTHEHEATERISBURNING5SE
the adjustment keys
TOADJUSTTHETEMPERATURE&IRSTPRESSEITHEROFTHETWO
keys to switch on the function (the °C mark
will start blinking). Next, adjust the
temperature using the key on the right (
쑿
min.) to set the temperature to a higher
setting and the key on the left (
쑼
HOUR TOLOWERTHETEMPERATURE0RESSONCETO
INCREASETHEVALUEONESTEP!FTERAPPROXIMATELYSECONDSTHEª#MARKWILLSTOP
BLINKINGANDTHESETTINGWILLBELOCKED&IG&
4HEAVAILABLETEMPERATURESETTINGSRANGEFROMª#MINIMUMTOª#MAXIMUM
When the heater has been unplugged (or after a power failure), the temperature
will reset to the factory setting of 20°C.
4
6
