Toyotomi TAG-A28IV, Руководство по обслуживанию

Страница: 19 / 44

– 18 –
TROUBLESHOOTING GUIDE
CHECK A FOLLOWING STEPS
ALARM
INDICATION TIME
APPEARANCE, PORTION, PARTS
SEEMED WRONG
METHOD OF CHECK
(press the ON/OFF button of remote controller in case of reset)
POWER
(green)
TIMER
(yellow)
OPERATE
(green)
INDICATION LAMP
check the drain hose by eyes (it might be folded or choked)
check the TAN whether lean or not
not cool down
not warm up
water leakage
louver doesn' t work
※
In this table TAN means indoor unit and TAG means outdoor unit.
check the resistance by tester [see fig.5]
check the point of leakage measure the pressure of compressor
during fixed operation (emergency and test operation)
nasty smell
FILTER IS CHOKED
NO USE FOR A LONG TIME
NASTY SMELL
(CIGARETTE, FURNITURE, ETC.)
DRAINAGE
MIS-INSTALLATION
LOUVER MOTOR
GAS LEAKAGE
SENSOR, TEMP. ROOM
SENSOR, TEMP. HEAT EXCHANGER
4-WAY VALVE
SHORT CYCLE
(INSUFFICIENT AIR CIRCULATION)
check by eyes and clean it
use deodorizer
check the resistance by tester [see table 1]
- - - -
- - - -
- - - -
- - - -
check the resistance by tester [see table 2]
FAN MOTOR (TAN)
check the voltage between blue and yellow in connector [see fig.3]
if it is AC 110V ~ 230V, TAN fan motor should be replaced
check the resistance by tester [see fig.4]
check the blockage of air inlet & outlet of TAN, TAG
common terminal
(5)
(1)
tester
resistance
terminal block
Normal:360 ~ 390
Ω
〔
fig. 3
〕
Voltage of TAN fan motor on the TAN PCB (main)
〔
fig. 1
〕
Voltage of TAG fan motor on the TAG PCB( main)
〔
fig. 4
〕
Resistance of 4-way valve coil
〔 fig. 5 〕 Resistance of TAN louver motor
※
Take off the connector and check the Resistance of 4-way valve coil.
Take off the connector and check the resistance between
the common terminal and each terminal.
Check the TAN PCB(main)
Measure the voltage between the connector pins in the back
of TAN PCB(main).
〔
fig. 2
〕
Continuity of current fuse on the TAG PCB(filter)
yellow
blue
red
tester
voltage
TAN fan motor
connector
4-way valve coil
1.5k
Ω
Normal:1.5k
Ω
0
Ω
TAG-A32IV
TAG-A28IV
TAG-A53IV
250V 12A
250V 15A
Measure the voltage between white and black in the connector.
11
AC230V
WBR
B
:BLACK
:BROWN
:WHITE B
BR
W
attention
electric shock Normal:110V ~ 230V
〔 fig. 6 〕 Voltage of TAN fan motor on the PCB(TAN main)
BL
PCB(TAG main)
TAN fan motor
connector
between red and black approx.DC325V
between yellow and black approx.DC3 ~5V
between white and black approx.DC15V
R Y B W
PCB(TAN main)
is Normal
Measure the voltage between
the connector pins inthe back
of PCB (TAN main) during
cooling operation.