3
FUEL GUIDE
The RCA-37WX is designed for use with high-quality kerosene (paraffin). Use of low-quality kerosene (paraffin) will
cause wick performance to drop, leading to “Iow flame” and “odor problem” conditions.
The kerosene commonly known as “industrial kerosene (paraffin)” is not suitable for your heater.
Purchase only kerosene (paraffin) in non-red cans reserved exclusively for kerosene (paraffin) and marked accordingly
with the word “KEROSENE (PARAFFIN)”. Always store your kerosene (paraffin) in a separate area from where you
store gasoline (petrol) for your power equipment, to avoid accidental use of gasoline (petrol) in your heater.
What to Buy...
ALWAYS: Crystal clear, colorless, high quality KEROSENE (PARAFFIN).
ALWAYS: Kerosene (paraffin) free of contaminants, water or cloudiness.
NEVER:
Gasoline (petrol), alcohol, white gas, camp stove fuel or additives.
NEVER:
Yellow or sour-smelling fuel.
How to Use lt...
ALWAYS: Fill heater away from living quarters when heater is cool; use siphon.
ALWAYS: Check wick frequently for tar build-up. (Rapid, heavy build-up may
indicate poor quality or deteriorated fuel.)
ALWAYS: Watch fuel gauge to avoid over-filling heater.
How to Store lt...
ALWAYS: ln a clean container, clearly marked KEROSENE (PARAFFIN).
ALWAYS: AWAY FROM direct sunlight, heat sources or extreme temperature changes.
NEVER:
ln a glass container, or one that has been used for other fuels.
NEVER:
For longer than 6 months. (Begin each heating season with fresh
kerosene (paraffin); discard at the end of the season.)
NEVER:
Accidental introduction of water into fuel containers.
Why lt is lmportant...
Pure, clean kerosene (paraffin) is essential for safe and efficient heater operation. Poor
quality or contaminated kerosene (paraffin) can cause:
●
Low flame
●
Excess tar deposits on the wick
●
Reduced wick life
●
Odor, smoke
●
Difficulty in igniting or extinguishing flame
Use of a highly volatile flammable fuel such as gasoline (petrol) can produce
uncontrollable flames, creating a severe fire hazard.
ASSE
INSPECTION AN
NOTE: Please save the shipp
1. REMOVE PACKING MATE
Open the grille by raisin
packing down by spread
packing, out of the cabine
2. REPLACE THE HEAT CHA
Remove the cardboard pa
heater.
Close the grille.
3. INSTALL THE BATTERIES
Locate the battery holder
●
Insert the battery 4 “C
markings.
4. CHECK THE HEAT CHAM
If the chamber is raised, p
NOTE: If the heat chamber is
FUELING
NEVER use gasoline (petr
WARNING: Use only cle
Flames observed emerging from the heater body are a clear indication that fuel is dangerously contaminated
with gasoline (petrol) or other highly flammable material. If this occurs,
a. NEVER attempt to move the heater.
b. Call the Fire Department.
c. Use only a class “B” fire extinguisher.
d. NEVER throw water directly on a burning heater.
CAUTlON
RCA-37WX_US.qxd 15.10.22 10:25 ページ 3
The RCA-37 (Type B) is designed for use with high-quality kerosene (paraffin). Use of low-quality kerosene (paraffin) will
The RS-W30 is designed for use with high-quality kerosene (paraffin). Use of low-quality kerosene (paraffin) will cause
wick performance to drop, leading to “Iow flame” and “odor problem” conditions.
The kerosene commonly known as “industrial kerosene (paraffin)” is not suitable for your heater.
Purchase only kerosene (paraffin) in non-red cans reserved exclusively for kerosene (paraffin) and marked accordingly
with the word “KEROSENE (PARAFFIN)”. Always store your kerosene (paraffin) in a separate area from where you
store gasoline (petrol) for your power equipment, to avoid accidental use of gasoline (petrol) in your heater.
4
ASSEMBLY AND OPERATION
INSPECTION AND ASSEMBLY
NOTE: Please save the shipping carton and packing materials for future storage of your heater.
1. REMOVE PACKING MATERIALS
Open the grille by raising the lower right hand corner of grille and pulling straight out. Slide the cardboard
packing down by spreading out to release the heat chamber assembly. Lift the heat chamber, in its protective
packing, out of the cabinet.
2. REPLACE THE HEAT CHAMBER
Remove the cardboard packing, and replace the heat chamber assembly. Point the wire handle to the front of the
heater.
Close the grille.
3. INSTALL THE BATTERIES
Locate the battery holder on the back of your heater.
●
Insert the battery 4 “C” size batteries according to the plus (+) and minus (–)
markings.
4. CHECK THE HEAT CHAMBER
If the chamber is raised, put it down and inlay it.
NOTE: If the heat chamber is raised, it can cause smoke and soot.
FUELING
NEVER use gasoline (petrol) or other flammable liquids.
WARNING: Use only clean kerosene (paraffin).
RCA-37WX_US.qxd 15.10.22 10:25 ページ 4
