PROGRAMMING
DRIVER’S DOOR/ALL DOORS UNLOCK SELECTION
The RS3200 is factory-set to unlock the driver’s door when the UNLOCK button is pressed on the remote
control, then unlock the remaining doors when the UNLOCK button is pressed again within 3 seconds. You
may change the programming so all doors will unlock at once when the UNLOCK button is pressed by fol-
lowing the steps below.
1. Before you begin:
2. Start the Programming Procedure.
Open the driver’s door.
(Complete these steps within 40 seconds.)
Remove the key from the ignition switch.
Note: If the system does not activate the lights and buzzer, start over.
Page 16
TOYOTA
RS3200 REMOTE KEYLESS Security system
TOYOTA
RS3200 remote keyless Security system
Page 5
FEATURES
FUNCTIONS
When an A
LARM
is T
RIGGERED
, the system disables the vehicle’s
starter and prevents engine start until the system is reset (D
ISARMED
).
During an A
LARM
, the system will lock the doors if one is unlocked,
and will continue to do so for the duration of the A
LARM
.
The user is notified that an A
LARM
occurred. Upon D
ISARMING
the
system after an A
LARM
was T
RIGGERED
, the vehicle’s tail and marker
lights will be turned on, and the B
UZZER
sounds, for 2 seconds.
You may T
RIGGER
a P
ANIC
A
LARM
, by pressing the P
ANIC
button on the
back of the remote control, to draw attention to your vehicle. During
the P
ANIC
A
LARM
, the head, tail and marker lights flash, and the horn
sounds, but the starter is not disabled.
The RS3200 flashes the vehicle’s tail and marker lights during
R
EMOTE
A
RMING
and R
EMOTE
D
ISARMING
, as well as during an A
LARM
.
Also, the headlights flash during an A
LARM
.
When the system is R
EMOTE
D
ISARMED
, it turns on the interior lights in
the vehicle for 30 seconds, or until the key is inserted into the
ignition switch. It also turns them on during an A
LARM
.
During an A
LARM
, the RS3200 activates the vehicle’s horn.
If power to the RS3200 is disrupted while it is A
RMED
, an A
LARM
is T
RIGGERED
once power is restored.
This panel houses the G
LASS
B
REAKAGE
S
ENSOR
microphone and the
flashing LED that indicates the operating status of the security system. (In
vehicles with an engine immobilizer system, that system’s LED and a
separate microphone are used instead.)
The RS3200 utilizes a P
IEZO
B
UZZER
, usually mounted in the engine
compartment, to sound confirmation “chirps” and tones for function
confirmation and programming step confirmation.
The RS3200 automatically locks your vehicle’s doors when you turn
the ignition key to “ON” or “START”, and unlocks the doors when you
turn the key back to “ACC” or “LOCK”.*
The Buzzer sounds for 5 seconds when you attempt to R
EMOTE
A
RM
the system while a door is open. You can stop the warning by closing the
door, or by pressing the UNLOCK button on the remote control.
The maximum operating range for the remote controls included with
the RS3200 is approximately 50 feet. Please refer to page 10 for a
description of factors that may affect the performance (operating
range) of the remote controls.
* You may disable this feature. Please refer to page 18 for programming information.
STARTER DISABLE
FORCED LOCK
DURING ALARM
TRIGGER MEMORY
PANIC MODE
OPERATION
EXTERIOR LIGHT
ACTIVATION
INTERIOR LIGHT
ACTIVATION
HORN ACTIVATION
POWER LOSS MEMORY
STATUS MONITOR
PIEZO BUZZER
IGNITION-
CONTROLLED
AUTOMATIC DOOR
LOCK/UNLOCK
DOOR AJAR WARNING
REMOTE CONTROL
TRANSMITTER RANGE
BRIEF DESCRIPTION–RS3200 FEATURES
a. Insert the key into,
and remove it
from the ignition
switch 2 times.
e. Insert the key into
the ignition and
leave it in.
c. Insert the key into,
and remove it
from the ignition
switch 1 time.
g. Turn the key from
LOCK to ON 4
times
(ending at
LOCK.)
h. Remove the key
from the ignition
switch.
b. Close, then open
the driver’s door
2 times.
f. Close the driver’s
door.
d. Close, then open
the driver’s door
2 times.
i. The tail and marker lights flash 4 times, the
buzzer chirps 4 times, and the doors lock and
unlock 4 times.
