PART NUMBER: PZQ72-
420
0
PAGE 6 OF 13
RAV4
CARGO BARRIER
ACCESSORY PART NUMBER: PZQ72-
420
0
2.
Removing upper trim panel.
1.18.
Reach under the trim panel and pull towards the centre of the
vehicle.
1.19.
With the trim levered from the car use both hands to
DISLODGE
the trim from the upper trim panel and the vehicle shell.
NOTE : Ensure care is taken when levering the lower trim panel
from the vehicle. Slowly lever the trim panel to preserve the
functionality of the small trim clips.
2.1.
Using a flat plastic trim removal tool, insert the tool between the
rear door seal and the upper trim panel as shown.
2.2.
Lever the upper trim panel from the vehicle and
DISLODGE
.
2.3.
Passenger side shown, repeat for drivers side.
3.1.
Cut out
TEMPLATE A
with scissors and place the drilling
template on the drivers wheel brace support as shown.
3.2.
Peel back the lower quarter trim and fix the template in place
with
masking
tape.
3.3.
Repeat for passenger side using
TEMPLATE B
.
3.4.
Using a centre punch, mark the three holes on the template.
3.5.
Using a 7mm drill bit, drill all three holes using a cordless
drill
as
shown.
3.6.
Using an 11mm drill bit, drill the centre hole using a cordless
drill.
3.7.
Drivers side shown. Repeat for passenger side.
3.
Installing lower mounting bracket.
DECEMBER 2012 ONWARDS
ISSUE 1
:
