Remote Engine Starter Troubleshooting Guide Page 12
DIAGNOSTIC MODE EXIT CONDITIONS
You may exit the Diagnostic Mode by doing either of the following:
1: Disconnect the diagnostic connectors.
OR
2: Wait 10 minutes from the time the diagnostic connectors were connected.
After completing the repair, the diagnostic connectors should be disconnected and re-secured prior to
reassembly of the trim covers.
NOTE
: The Remote Engine Starter will store the code for the last engine stop factor in its memory, even
after exiting Diagnostic Mode. The code cannot be cleared from the Remote Engine Starter ECU’s memory.
DIAGNOSTIC CODE BY SCAN TOOL
When RES has the following defects, diagnostic code is indicated by the scan tool.
1: Internal Relay of the RES ECU Abnormality Detected CODE [
B2334
]
2: Internal Switch of the RES ECU for Vehicle Starter Abnormality Detected CODE [
B2333
]
If you find the above code by the scan tool, PLEASE CALL Fujitsu Ten Technical Support at (800) 237-5413.
