Toyota BT Levio LWE140, Руководство по эксплуатации продукта

Страница: 32 / 81

Product details
Product guide – BT Levio W-series
32
Operator parameters
To reprogram operator-specific parameters (if the change is permitted), proceed as
follows:
● Press the horn button and keep it pressed while starting the truck using either
PIN code entry or the ID unit.
● Release the horn button when the display shows “P”.
The parameter symbol on the display lights.
● Use the speed control to scroll to the desired parameter.
● Press the horn button once to change the value.
The parameter symbol on the display starts flashing.
● Change the value by turning the speed control.
● Confirm by pressing the horn button once more.
The parameter symbol on the display stops flashing and remains lit.
● Complete programming by pressing "O” (red key) on the keypad or the ID unit.
The following table lists available operator parameters.
Parameters
No. Parameter type Unit Min./
Max.
Slow
value
Std.
value
Max
Perf.
Notes
4 Acceleration % 10–100 60 80 100 10: Slow acceleration
100: Fast acceleration
In increments of 5
5 Automatic speed
reduction power % 10–100 90 90 100 Speed reduction when the speed control
is released to neutral position
10: Slow speed reduction
100: Fast speed reduction
In increments of 5
6 Top speed on % 10–100 90 100 100 10: Lowest top speed setting
100: Highest top speed
setting In steps of 5
There is a pre-set limit so that parameter 7
never exceeds parameter 6.
7 Turtle button % 10–100 50 50 50 Press the turtle button to reduce speed temporarily.
The next time the button is pressed, the speed will
revert to the normal parameter 6 value.
The display alternately shows battery status
and SLO (slow).
10: Low speed
100: High speed
In increments of 5