TOYOTA
TUNDRA
Billet Grille w/LED DRL
Picture 22
29. Secure excess wires at both sides with
wires ties, leaving enough lead to connect
the DRL to the harness (picture 23)
Picture 23
30. Secure excess wires with wire ties (pic. 24)
Picture 24
Billet Grille Installation
31. Take the two Z support brackets and install
them on backside of the factory grille shell
with the arm bending downward as shown
(picture 25). Use the factory screws
removed in Step 4 along with one 1” black
fender washer on each bracket to secure
the bracket to the factory grille shell. Repeat
this on the opposite side of the factory grille.
Tighten the two screws.
Picture 25
32. Take the two top plate extension brackets
and install them on the upper corners of the
factory grille shell using the factory screws
to secure them to the grille shell and install
the u-nuts onto the arms of the brackets as
shown in (picture 26). Insure the u-nut is
oriented with the side that accepts the
screw facing outward as shown.
Picture 26
Southeast Toyota Distributors, LLC
Page 9 of 16
