TOYOTA
TUNDRA
Billet Grille w/LED DRL
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of
this accessory should follow approved guidelines to ensure quality installation
.
These guidelines can be found in the
Accessory Installation Practices document. This document covers such items as:
•
Vehicle Protection (use of covers and blankets, cleaning chemicals, etc)
•
Safety (eye protection)
•
Vehicle Disassembly / Reassembly (panel removal, part storage, etc)
Preparation
Remove negative battery cable
Installation
1.
From front of vehicle, lay the DRL’s wire
harness on the engine compartment, left
side from the battery towards the firewall of
the car (pictures A and B).
Picture A
Picture B
2.
Locate the large vehicle harness grommet
on the left side. If accessible, cut the
auxiliary wiring access nipple off the
grommet or cut
¼
” slit in grommet and push
the red, black, black-white and red-white
wires through firewall. Note: Extra caution
should be taken not to damage the
connector’s pin. Seal with 3M Silicone
sealant (picture 1)
Southeast Toyota Distributors, LLC
Page 2 of 16
