5.
SPECIFICATIONS
TRAILER
The complete generator is housed in lockable enclosure with the frame fabricated from heavy
gauge steel mooned on a two-wheel, leaf spring axle.
When the mast is in the operating position it is located in the middle of a three-point outrigger
system for optimum balance and stability. This system was engineered to allow the high tower
to remain operational in sustained winds of 70 km/hr with the mast extended full height and
the outrigger in position.
MAST
The mast consist of a three section steel tube that extends 9m.
The mast is extended with two manual winches. The mast includes self-lubricating nylon
guide pads and a 360-degree Rota table light bar.
STABILIZERS
The three-points outrigger design consists of two retractable side outriggers and a hydraulic
jack.
FLOOD LIGHT
The flood light assembly consists of four 1000-watt lamp or four 400-watt LED lamp fixtures
sealed for all weather use.
Laboratory rated life is 12,000 hours
Warm up time:2-4 minutes
Restart time:10-15
TOWING INSTRUCTION
Before towing the trailer should be inspected visually to insure that the following operations
have been completed:
1.
Hitch is securely attached to the towing vehicle(safety chain securely attached)
2.
All outriggers and jacks are retracted and secured.
3.
Rear tower support pin is in the locked position.
4.
Light fixtures are positioned for transport.
5.
Doors are closed and secure.
6.
Check for adequate tire pressure.
7.
Trail lights are connected and operational.
6.
GENERATOR INSTRUCTION
PREPARATION BEFORE OPERATION
a.
Add anti-freezing liquid to ready diesel generator.
b.
Verify and add oil to generator, if necessary. Too much or too less are bad for engines.
c.
Connect the diesel line, exhaust air in oil tube to make it easy to start diesel generator. It’s
better to use 0# 0r -10# diesel.
d.
Choose wire with right capacity based on power of generator to be connected to output end
of main circuit breaker. Connect phase line and null line with right position. Also connect
the connection line based on drawing.
e.
Make sure all ground connection good such as controller, generator body and etc.
