Town & Country Fireplaces TCWS.54NG03C2, Инструкция по эксплуатации

Страница: 3 / 12

TCWS.54NG03C2 230911-12
If converting to propane see
conversion instructions on page #5
before proceeding.
Install panels according to the
TCWS.54CE2 Installation and
Operating manual prior to burner
installation. (Page 23)
1. Install the right burner by laying into
location trough and sliding to the right
to engage the venturi tube over the
orifi ce. Repeat with left burner. (Fig.
#1)
NOTE: check air shutter for correct fuel
setting before proceeding further. Both
burner shutters are to be set the same,
fully closed for natural gas. 13/64 (0.2)”
open for LP.
CAUTION: The burners should be tightly
butted up against each other at the center
to ensure correct operation.
2. Tilt the burner tray into the unit and place
on top of the manifold brackets(Fig.#2).
Attach pilot to burner tray. Be sure pilot
is attached to burner support rail with
screw in
fi rst hole position.
(Fig. #2a)
3. Secure the burner tray to manifold
brackets using eight screws(Fig. #3).
Black Diamond Burner Installation
FIRST HOLE POSITION
Fig #2
Fig #3
Fig #1
Fig #2a
3