Fig #16
TCWS.38NG03.C 080709-12
WARNING
This conversion kit
shall be installed by a
qualified service agency
in accordance with the
manufacturer's instructions
and all applicable codes
and requirements of
the authority having
jurisdiction.
If the information in these
instructions is not followed
exactly, a fire, explosion
or production of carbon
monoxide may result
causing property damage,
personal injury or loss of
life.
The qualified service
agency is responsible for
the proper installation of
this kit.
The installation is not
proper and complete
until the operation of the
converted appliance is
checked as specified in the
manufacturer's instructions
supplied with the kit.
If the unit is to be used with propane
convert as follows using the compo-
nents supplied with this burner:
CAUTION
The gas supply and electrical power
shall be shut off before proceeding
with the conversion.
Caution:
Factory supplied components must be
used to ensure correct input.
After conversion confirm proper manifold
pressure.
1. If installed remove the glass media from
the burners.
2. If installed remove the burner from the
burner tray. Gently lift up the left side of
the burner and disengage the venturi
tube from the orifice. (Fig. #14)
3. using a 1/2” wrench, undo the
natural gas burner orifice, (Fig #15)
(marked
#40
). Apply a small amount
of pipe joint compound to the threads
of the propane burner orifice
(marked
1.45mm
) to ensure a good
seal, before screwing it into the fitting.
Loosen the primary air shutter screw,
open shutter to give a gap of 1/8”
(0.125”) and re-tighten. Repeat on
other burner. (Fig. #15a)
4. With a 7/16” wrench loosen the pilot
head on the pilot assembly. (Fig. #16)
Propane Conversion
Fig #15
Fig #14
Fig #15a
MAIN BuRNER
(1.45mm) ORIFICES (5022.8)
MINIMuM RATE SCREW (5005.015)
CONVERSION lABEl (5052.52087)
6
