Town & Country Fireplaces 22150036, Руководство по установке

Страница: 5 / 16

5
TC42_NG06D_050919-16
100000385
Ember Material
A large bag of glowing ember
material is supplied with the
burner kit and needs to be
installed on the burner to ensure
optimum performance and flame
appearance.
1. Pull apart the material
into ember size pieces
(approximately 1” squares)
and gently place them into the
burner pan. Do not compress,
leave them loose for best
performance.
2. Fill the burner pan level with
the top of the pan at rear, and
gradually sloping forward down
to the firebox floor at the front,
covering both burner tubes.
3. Place remaining ember
material outside of the burner
pan as desired to cover-up gas
lines and brackets.
Gas plumbing and vent
connections should be completed
before proceeding.
The logs are fragile and should be
handled with care. Unpack and
inspect log set. There should be a
total of 7 logs.
Position the logs as indicated by
the following pictures. Place the
rear log back against the tabs
located at the back of the grate.
(Figure 10).
Log Set Assembly
Note: Ember material placement and amount will affect flame
appearance. More ember material results in lower flame height.
Add or remove as needed until desired flame affect.
Log grate
Glowing embers
Figure 9: Ember material placement.
Log 1
Figure 10: Log 1 placement.