25
46
1.
Cut the decals from the decal sheet.
2.
Be certain the model is clean and free from oily fingerprints and dust. Prepare a pan or small bucket with a
mixture of liquid soap and warm water – ½ teaspoon of soap per gallon of water. Submerse one of the decals
in the solution and peel off the paper backing. NOTE: Even though the decals have a “sticky-back” and are not
the water transfer type, submersing them in soap and water allows accurate positioning and reduces air bubbles
underneath.
3.
Position decal on the model where desired. Holding the decal down, use a paper towel to wipe most of the
water away.
4.
Use a piece of soft balsa or something similar to squeegee the remaining water from under the decal. Apply the
rest of the decals using the same method.
47
GET THE MODEL READY TO FLY
APPLY THE DECALS
Check the Control Directions
CAUTION: DO NOT
install the propeller until
instructed to do so.
1.
Temporarily install the wing with the aileron servos
connected. Switch on the transmitter with the throttle
stick in the lowest position and connect the flight
battery to the ESC. Center the trims on the transmitter
and the servo arms on the servos.
2.
Center the control surfaces.
3.
Make certain that the control surfaces respond in
the correct direction as shown in the diagram. If
any of the controls respond in the wrong direction,
use the servo reversing in the transmitter to
reverse the servos connected to those controls.
Be
certain the control surfaces have remained
centered. Adjust if necessary.
FULL THROTTLE
RUDDER
MOVES RIGHT
ELEVATOR MOVES DOWN
RIGHT AILERON MOVES UP
LEFT AILERON MOVES DOWN
58575.1 TOWA2042 Slow Ride Manual Update.indd 25
5/22/18 9:31 AM
