Tower Hobbies NO GRAVITY, Руководство пользователя

Страница: 6 / 12

14.1.Remove one clip from the elevator pushrod, then pass the pushrod through the
pushrod guiding tube.
14.2.Put on the removed clip on pushrod.
14.3.Install the elevator pushrod, one end connected to control horn, another end
connected to servo arm. You can adjust the length of pushrod with clips on the
two ends.
15.1.Thread the pull-pull fishing line through the rudder servo hole, then fix it with glue.
15.2.Adjust the pull-pull line to a proper length, and pass another end of fishing line
through the servo arm, then fix it with screw and washer as picture shown.
16. Vector system installation
16
.
1
.
Install the motor on vector system, then fix it with screws.
16.2.Connect the vector stystem pushrod with Z bend to the corresponding
holes.
16.3.Install vector system on motor mount with screws. And pass the
pushrod wire through the hole on adjustor, then adjust the wire length
with screw on adjustor.
NO GRAVITY