Tout Terrain SINGLETRAILER, Руководство пользователя

Страница: 11 / 16

11
3. The rear wheel is fitted with the quick-
release axle which is attached to the swing-
arm as shown below (a). Once the wheel
is mounted, affix the rubber hub/axle cover
to protect the components (b).
Warning: Make sure that the wheel is
securely attached. This is indicated when
the spring-loaded thru-axle shaft returns
completely into the thru-axle - the shaft
will sit flush with the axle.
4. Pull the seat post out of the bicycle frame.
Take out the hitch, which is fastened to the
seat post, out of the coupler and slide it onto
the seat post. The hitch must fit securely
onto the seat post. Make sure to install the
correct hitch and shim. The hitch should not
have any play at the seatpost. You should not
need to open the hitch more than 1 mm –
any more and the hitch is too tight. Re-insert
the seatpost into the frame and position the
hitch close to the frame, but high enough
such that you can lower the seat post if
necessary. The hitch must be aligned with
the rear of the bike, and tightened with
a 5 mm allen key to a maximum of 9 Nm.
Warning: Do not mount the trailer to carbon
or other lightweight seat posts. For dropper
posts please make sure to follow all manufac-
turer instructions.
5. Attaching the trailer to the bike: The coupler
quick release must be open and the hitch
and coupler must be free of contamination
(eg. dirt, water, grease). Push the coupler
over the hitch until it is completely inserted
(the coupler will almost contact the seat
post). This is easiest when the trailer is rest-
ing on its stand: grasp the trailer coupler with
one hand, and move the bicycle and hitch
towards coupler with the other. Make sure
that the Singletrailer hangs straight behind
the bike. Proceed as follows:
b)
a)