TouchTunes DA415, Быстрый старт

Страница: 14 / 20

14
Hardware Overview and Installation
You can purchase pre-wired cable, or you can wire your own cable as follows:
1
2
3
4
5
6
7
8
white + orange
orange
white + green
blue
white + blue
green
white + brown
brown
white + orange
orange
white + green
blue
white + blue
green
white + brown
brown
1
2
3
4
5
6
7
8
Near
End
Color Color
Far
End
Straight-through catagory 5 cable wiring
RJ45 connector
RJ45 Cable Wiring
4. Left channel audio output connector
Provides audio out at 150W/4 ohms for two satellites using a euroblock connector.
5. Right channel audio output connector
Provides audio out at 150W/4 ohms for two satellites using a euroblock connector.
6. Bass channel audio output connector
Provides audio out at 300W/8 ohms for a subwoofer.
Installation
Please refer to the figure on page 13 while performing the installation.
1. Ensure that the power supply cord is disconnected from the power connector on the DA415
amplifier.
2. Connect a standard category 5 cable with RJ45 connectors from the Zone 1 output on the
MJS to the input connector (3) on the DA415 amplifier.
3. Connect the left and right Mini-Platinum satellite speakers to the DA415 by pressing their
euroblock connectors firmly into the left and right channel audio output connectors (4 and 5)
on the DA415 amplifier.
4. Connect the Mini-Platinum subwoofer to the DA415 by pressing the connector into the bass
channel audio output connector (6) on the amplifier.
CAUTION: Incorrect speaker installation or speaker wiring configuration can cause
severe damage to the amplifier. If you have not already done so, please refer to
“Speaker Wiring Guide” on page 11 before proceeding.
5. Optional: Connect the DA415 to other audio equipment (for example, a second Mini-
Platinum speaker system) using a standard category 5 cable with RJ45 connectors.
6. Power up the unit by connecting the power cord between a properly grounded wall outlet
(AC 120V /60Hz MAX 1000W) and the power connector on the amplifier.