Touch Dynamic PR-TB4, Руководство по оборудованию

Страница: 17 / 21

- 14 -
(2) Attach the holding plate to the printer. Then tighten the two screws that were supplied to secure it in place.
(3) Position the printer over the screws, etc., on the wall and then slide it downward to set it in place. After setting the printer
in place, check the screws on the wall again to make sure that they are able to support the printer’s weight.
(4) Open the printer cover.
(5) Insert the roll paper as shown.
Note 1: The printer’s weight is approximately 2.4 kg when the largest diameter roll paper is loaded. Use screws on
the wall that have both shear strength and pulling-out strength to withstand a force of at least 12 kgf (118
N).
2: When installing the printer on a wall, be sure the installation surface of the printer has an angle between
0 to +10 degrees with respect to the wall. If the installation angle of the printer with respect to the wall is
negative, paper near end may not be detected correctly.
0 ~ +10°
2
〜
3mm
Rubber feet and the like