Totoku LV22P2, Руководство пользователя

Страница: 10 / 64

- 8 -
ENGLISH
Connecting the display
Important
When using LV22P2 on a ME253i2 display...
ME253i2 is loaded with two sets of Extended Display Identification Data (EDID). EDID
is a data structure stored within a display describing its own information including
supporting resolution. Both landscape and portrait display modes (resolutions) are
supported but they need to be manually switched. By default, ME253i2 is set to
landscape mode.
Make sure to change the display mode (switch EDIDs) to use ME253i2 in portrait
orientation according to the display user manual.
The currently used display orientation on ME253i2 can be found out by counting how
many times the LED blinks upon turn-on with the DVI cable being disconnected. See the
table below.
Display mode LED behavior upon turn-on
Portrait
The LED blinks just once.
Landscape
(Default)
The LED blinks twice.
Connect the supplied DVI split cable to the DMS59 connector on the card and tighten
the screws on the connector.
Important: Carefully insert the DMS59 connector of the DVI split cable straight.
Inserting the connector at an angle may cause the connector pins to bend.
2
Connect the DVI cable supplied with the display between the graphics card's DVI
connector and the display and tighten the screws.
Note: This graphics card has two DVI connectors: 1 and 2. Make sure to connect the
first display to Connector .
Do not connect/disconnect the DVI cable while the display is turned on. It could
cause a graphics card failure. Connect/disconnect the DVI cables with the
display disconnected.
Caution