40
41
What to Do?
Long Periods of Disuse
Troubleshooting
First, try the actions described on pages 41 to 44.If the problem
persists, consult the installer, seller or the contact listed on the
back cover of this manual.
CAUTION
If a water leak occurs, close the
shuto
ff
valve.
Please check
fi
rst
Is the
POWER LED lit?
■
SW2043R
Is the POWER LED
fl
ickering?
➞
The main unit is not mounted properly.
Mount the main unit again. (Page 28)
■
Is the breaker on the
distribution board turned
on?
➞
Check whether there is a power
outage or the breaker has turned
"OFF".
Lit
Is the ENERGY
SAVER LED lit?
■
While the LED is lit, energy saver
(Page 24)
is in operation,
so the toilet seat temperature may be reduced or the
warm water heater and toilet seat heater may be turned
o
ff
.
Is the remote
control working?
■
Are the remote control
batteries dead?
➞
Replace the batteries. (Page 38)
■
Is the remote control
transmitter or the remote
control receiver blocked?
➞
Remove obstructions, dirt, water
droplets or any other blockages.
Close
Open
Battery cover
The remote
control uses
batteries
to operate.
Remote control
transmitter
Remote control receiver
How to drain the water
1
Drain the water from the toilet tank.
(Procedures and in "Freeze damage prevention" on page 38)
2
Drain the pipe.
(Step
3
(1) to (5) on Page 39)
* After draining water, keep the cover removed.
3
Remove the water drain
plug.
The water comes out from near the
wand for about 90 seconds.
Water drain plug
4
Reinstall the water drain plug and
cover.
●
Putting antifreeze in the water remaining in the toilet bowl will reduce its chance of freezing.
(The antifreeze solution should not be
fl
ushed out. Collect it before using the toilet and dispose of it.)
■
To use the Washlet again
• The water needs to be resupplied. (Page 39)
If the toilet is in a location you will not visit for a long time, drain the water.
(The water in the tank may become contaminated and cause skin irritation or other problems.)
Reference