Toto TBV02403, Руководство пользователя

Страница: 31 / 52

30
Please do not use items that may break the faucet.
▪ Acidic detergents, chlorine bleach and alkaline detergents besides
cleaners for the area around TOTO faucets
It may cause the surface of the faucet to discolor or the resin parts to
break.
▪ Solvents such as thinners, benzene and the like
The rubber and resin parts may break.
▪ Detergents containing cleansers, scouring powders and the like and
other detergents containing coarse particles
▪ Nylon scourers, scourers, brushes and the like
The surface of the faucet will be scratched.
Please note
● For light soiling
Remove the dirt by wiping it off with a well wrung cloth soaked in cold or
lukewarm water.
● For heavy soiling
Remove the dirt by wiping it off with a cloth with an appropriate amount
of diluted neutral detergent for bathrooms, wash it off with water then
dry wipe it.
● If the flow lines are disrupted
If the nozzle is jammed the flow lines may be disrupted. Remove the
dirt of the nozzle by lightly wiping it off with a soft, well wrung cloth
soaked in cold or lukewarm water. Be careful as wiping or rubbing with
strong force, may cause the nozzle to break or deform leading to further
disruption of the flow lines.
B-2
Maintenance using a cloth
B-3
29
For models with a bath spout
8. Match the resin plate to the base, fix it with four screws and attach the
plate.
For the attachment screws, tighten them until the seal material on the
resin plate collapses (the gap between the resin plate and the wall
disappears).
Push in the plate until the gap between the plate and the wall is less
than 1 mm.
After attaching the plate remove the curing material.
9. Match the switching (open/close) handle lever and the " " of the
plate and insert them all the way in.
10. For the switching (open/close) handle lever, use an hexagonal bar
wrench to tighten the stopper screws.
11. Set the safety button of the temperature regulating handle to match
the "40" mark on the plate and push it in.
12. Fix the machine screws and push in the cap.
13. After fixing check that hot water at the appropriate temperature
(approximately 40°C) comes out.
EN
Model TBP02001
1. Loosen the screws (4) and remove the spout cap.
Avoid losing the screws.
2. Remove any garbage and dirt stuck in the filter and straightening plate
with a toothbrush or the like.
3. Attach the filter, straightening plate and the spout cap.