8
Note
7
-4
. Mounting the Fixing Bracket on the Wall
Notes
*Be sure to hand over the instruction manual to the customer.
①
In the handrail mounting position, fix the mounting bracket for light-gauge steel frames to
the reinforcing light-gauge steel frames (t 2.3 mm or more) with drilling screws.
②
After finishing the wall, carry out handrail centering and make
φ
8.5-mm prepared holes for
M10 tapping.
Make about
φ
11-mm through holes in the wall finishing area.
③
Make M10 tapped holes in the mounting bracket for light-gauge steel frames.
④
Screw continuous-thread studs and adjust their projecting length to be between 12 and 18
mm from the finished wall surface.
①
In the handrail mounting position, fix the mounting bracket for light-gauge steel frames to the
reinforcing light-gauge steel frames (t 2.3 mm or more) with drilling screws.
②
After finishing the wall, carry out handrail centering and make
φ
16-mm through holes for mechanical nuts.
③
Insert the mechanical nuts into the through holes and set them.
④
Screw continuous-thread studs and adjust their projecting length to be between 12 and 18 mm from
the finished wall surface.
Note 1
Note 1
Note 2
Note 2
Through hole(
φ
16)
Continuous-
thread stud
12 to 18
Mounting bracket
Mechanical nut
Through hole (
φ
11)
Plywood, etc.
Plywood, etc.
Prepared hole(
φ
8.5)
for M10 tapping
Continuous-
thread stud
Finished
wall surface
Finished wall surface
12 to 18
Mounting bracket
Stud
Mounting bracket
Reinforcing
material
(t = 2.3 or more)
(Unit: mm)
Make sure that the handrail has no backlash.
Checking for backlash
Is the handrail firmly secured to the
wall?
8. Inspection Items
Light-gauge steel base: Fixing with bolts
Light-gauge steel base: Fixing with mechanical nuts
7
.
See
Mounting the Fixing
Bracket on the Wall.
Fixing bracket part number T110D53
Fixing bracket part number T110D54
Make sure that the paper holder has no backlash.
Is the paper holder firmly secured?
2.
See
Handrail with paper
holder (T112HP type).
*After finishing the wall,
you can adjust the
handrail-mounting
position within the range
of the mounting bracket.
Note 1: Use reinforcing light-gauge steel frames that
are t 2.3 mm or more.
Note 2: Adjust the projecting length of the bolts of the
mounting plate to be between 12 and 18 mm
from the finished wall surface.
After the installation is
complete, confirm the
following items:
*For installation methods not shown in this manual, please
contact TOTO’s branch office, branch shop, or sales office.
