Precautions before installation
2
-1
. Before Installation
About the resin coating type and combination type grip bars
2
●
Checking the assembly parts
●
Confirming the installation direction
③
Paper holder unit
③
Paper holder unit
④
Spring washer (2 pieces)
④
Spring washer
⑤
Hexagon socket head cap screw
Flip-up handrail
Toilet
⑤
Hexagon socket head cap screw
(M4 × 35: 2 pieces)
5.
3.
Handrail with paper holder (T112HP type)
<Remedial method>
Grip bar
Note
①
Face nut
Make sure that you have the following parts:
There are the right side type and the left side type for paper holders. Before fixing
the product to the wall, install the paper holder unit correctly according to the
position of the toilet as shown in the figure below.
①
Face nut (2 pieces)
②
Washer (2 pieces)
②
Washer
Prepared hole
in the body
Curved surface
Protruding portion
(female thread)
Curved surface
Protruding portion
(through hole)
Right side
When installing the handrail on the right side as you face the toilet When installing the handrail on the left side as you face the toilet
Left side
Flip-up handrail
Toilet
③
Paper holder unit
④
Spring washer
⑤
Hexagon socket head cap screw
①
Face nut
②
Washer
Prepared hole
in the body
●
Make sure that
the wall where the handrail is attached
is strong enough.
●
Select an appropriate installation method depending on the building
structure.
As the part number of the handrail and that of the wall-fixing bracket are different,
please place an order for the fixing brackets separately depending on the wall
structure. One fixing bracket is required for one handrail. See “ Fixing Brackets
(Optional Parts)” for the required number of fixing bracket sets.
*For fixing methods not shown in this manual, contact TOTO’s branch office, branch
shop, or sales office.
●
Make sure that
there is no obstacle in the handrail moving area
.
See “ Completion Drawing” for the moving area.
●
See the catalogue, etc. for the handrail installation position.
●
Check the functions of the flip-up type after installation, not before
installation.
The flip-up type fulfills its functions only after it is installed on a wall, so if you move
the grip bar without attaching the handrail to the wall, you may feel it heavy.
●
If the resin coating type or combination type grip bar gets scratched on
its surface, it cannot be repaired. Therefore, please handle the product
with care.
●
As the surface of the resin coating type or combination type grip bar is
made of soft resin, if a tool or the like hits the grip bar, the surface of the
grip bar may get dented. In that case, remedy it by the following procedure.
Apply hot air to the dented portion with a
hair dryer for about 2 or 3 minutes.
*The time to apply hot air varies depending
on the degree of the dent. Remedy it while
checking its recovering condition.
Do not apply hot air to the soft resin on the surface of the resin
coating type or combination type grip bar too long.
Doing so may cause the soft resin portion to burn or change in color.
1. Put the hexagon socket head cap screw (
⑤
) through the spring washer (
④
),
the paper holder unit(
③
), and washer (
②
) in this order, and then insert the
protruding portion of the washer into the prepared hole in the body.
2. Insert the protruding portion of the face nut (
①
) into the prepared hole of the
body on the opposite side of the washer (
②
).
