Toto 20899, Руководство пользователя

Страница: 10 / 96

Checking the Engine-Oil
Level
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out (
Figure 16 ).
g232743
Figure 16
1. Full 3. Add
2. High
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
5. Read the oil level on the dipstick ( Figure 16 ).
•
If the oil level on the dipstick is too low
(
Figure 16 ), carefully pour a small amount
of SAE 30 or SAE 10W-30 detergent oil into
the oil-fill tube, wait 3 minutes, and repeat
steps
3 through 5 until the oil on the dipstick
is at the correct level.
•
If the oil level on the dipstick is too high
(
Figure 16 ), drain the excess oil until the oil
on the dipstick is at the correct level; refer to
Changing the Engine Oil (page 18) .
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
6. Install the dipstick into the oil-fill tube securely.
Adjusting the Upper Handle
Height
You may raise or lower the upper handle to a position
comfortable for you.
Note:
You cannot raise the upper handle higher than
the angle of the lower handle.
1. Loosen the upper-handle knob ( Figure 17 ).
g010334
Figure 17
2. Move the upper handle to the desired position
(
Figure 18 ).
g010265
Figure 18
3. Tighten the upper handle knob as tight as you
can (
Figure 19 ).
g010352
Figure 19
9