8
Flow Rate Adjustment
The volume of the material will be adjusted by turning
the flow regulator screw.
Spray methods
The result of spraying depends fundamentally on how smooth and clean the surface is
before spraying. Therefore, the surface must be pre-treated and free of dust.
Those parts of the surface or object to be sprayed must be covered with an adhesive
tape or newspaper so as not to be sprayed. Also cover screws or the like on the object
being sprayed.
It is important to pre-work cardboard or a similar surface spray sample to find the correct
spray gun setting.
Attention
Make sure the surface to be painted is continuous and allows you to move safely. Avoid
spray cuts in the intended path.
a) Figure 11: Keep the spray gun necessarily at the same distance of about 5-15cm
to the object being sprayed.
b) Figure 12: Make multiple passes to get a better result.
Move the spray gun evenly from side to side or up and down, depending on the
projection fan setting.
An even motion when painting will give you a better quality finish.
c) Clean as coating material builds up on the nozzle and air cap (A and B) both parts
with solvents or water.
W
ork stoppages
•
Power off the device.
•
Place the spray gun on the spray gun holder.
Cleaning
•
Power off the device.
•
Press the trigger so that the paint returns to the container.
•
Unscrew the container.
•
Empty the remaining paint.
+
Turn Right More Flow Rate
-
Turn left Lower flow rate
Содержание TSGLI2001
Страница 1: ...1 v BATTERY POWERED PAINT GUN...
Страница 12: ...12 BATTERY POWERED PAINT GUN...