9
Using the pendulum jigsaw
Attention
Before using the saw and connecting the power cord, make sure the trigger switch is in
the off position.
•
Press the trigger and wait until the blade has reached full speed.
•
Place the face of the base plate on the workpiece and align the cut line with the
line you want to cut.
•
Slowly push forward.
•
Keep the base plate flat against the workpiece.
Metal cutting
A suitable lubricant or similar liquid should always be used (such as light oil, small
amounts of soapy water, etc.). If no lubricant or similar liquid is available, grease can be
applied to the back surface of the material to be cut.
Window Slot / Hole Cutting
•
For wood:
o
Align the direction of the blade with the grain of the wood.
o
Next, place the rounded portion at the front of the base plate on the
surface to be cut, slowly lower the saw into the material at your chosen
entry point.
o
Lower the saw in a pivoting action until the blade has cut to the other side,
do not move the saw along the intended line of cut until the blade has cut
and the base plate is resting on the material.
•
For materials other than wood, when cutting window holes first use a drill or
similar tool to drill a hole from which the initial cut will begin.
court
angular
The angle adjustment screw has been combined with the lever. To adjust the tilt angle,
loosen the angle adjustment screw by turning the lever counterclockwise.
