5 //
TOTAL GYM
®
2.
Remove any additional packaging from the unit. Attach the
bungee cord to the bottom bungee hook. Ensure both ends of the
bungee cord are hooked securely.
3.
Unfold the vertical column from under the unit and place the
safety hitch pin (height adjustment) into the highest position.
Secure the safety hitch pin (support frame) into the support frame.
Next, thread the height adjustment knob into the hole on the back of
the vertical column and tighten with wrench.
4.
Carefully lift the mast and attach it to the unit frame by sliding
the mast tube into the frame bracket. When the mast is correctly
attached it will stand without handheld support. Secure the mast
into the unit frame using (3) three allen bolts, (3) three washers,
(2) two rubber foot pads and allen wrench. Start with the middle
bolt/washer and then move to the side bolts/washers/rubber foot
pads. For the side assembly, thread the bolt with washer through
the rubber foot pad
(fl
at edge facing the bottom of the unit) into the
frame. Do not completely tighten one bolt until all three are at least
halfway inserted.
ASSEMBLY
PARTS & TOOLS:
•
(1) Seat
•
(1) Handle
•
(1) Monitor, (1) Monitor Bracket & (2) AA Batteries
•
(1) Height Adjustment Knob
•
(1) Blister Pack with
(9) Allen Bolts M6x16, (2) Allen Bolts M6x30,
(2) Allen Bolts M6x50, (9) Flat Washers M6, (1) Allen Wrench,
(2) Rubber Foot Pads & (1) Wrench
•
(1) Device Holder, (1) Device Holder Base, (1) Device Holder Arm
& (1) Twist Screw
HOW TO ASSEMBLE:
1.
Carefully remove all packaging from the unit, remove the unit
from the box, and lay on the ground.
IMPORTANT:
Use caution when lifting and removing the unit frame
from the box. The mast (as shown below) is already connected to
the frame. Lay the mast at the bottom of the unit.
+
+
BUNGEE
HOOK
BUNGEE CORD
UNDER MAIN FRAME VIEW
BUNGEE HOOK
VERTICAL
COLUMN
SAFETY
HITCH PIN
SUPPORT FRAME
SAFETY
HITCH PIN
HEIGHT
ADJUSTMENT
HEIGHT
ADJUSTMENT
KNOB
SUPPORT
FRAME
WRENCH
(3) ALLEN BOLTS
M6X16
(3) WASHERS
(2) RUBBER
FOOT PADS
MAST TUBE
FRAME
BRACKET
SIDE
SIDE
MIDDLE
ALLEN WRENCH
TG_inclinerow_ownersmanual.indd 5
6/1/21 9:45 AM
