3. Align the Expansion Bus Connector over
the QP-Ethernet Series unit's Rear Face
Expansion Unit I/F. Then, press the Unit
down so that the two unit's connect.
5. Insert the expansion unit Attachment Tabs
into the QP-Ethernet unit Attachment
Slots. Be sure to install the expansion unit
so that its smooth metal surface faces out-
ward.
4. After the two connectors are securely at-
tached, insert the four (4) attachment
screws into the four (4) attachment screw
holes and tighten the screws. Be sure that
no gaps remain between the QP-Ethernet
Series unit and the Unit.
6. Attach the expansion unit to the Bus Con-
version unit and tighten the two (2) ex-
pansion unit attachment screws (included
with unit).
Attachment
Screw Holes
Attachment Screws
Attachment Tabs
Expansion Unit Users Manual
A torque of only 0.5 to 0.6 N•m is
required to tighten an attachment
screw. Be careful not to use too
much force, since it may damage
the QP-Ethernet unit.
Expansion Bus
Connector
Expansion
Unit I/F
Note
Please be aware that Total Control Products shall not be held liable
by the user for any damages, losses, or third party claims arising from
the uses of this product.
