31
Set the start time, end time, channel and tape
speed as in step 4.
EXIT
SET
SELECT
: MENU
:
OK : ENTER
:
TIMER REC SET
DATE
START
END
CH
SPEED
23 SAT
3
LP
PDC
OFF
13 : 00
14 : 30
To set the timer for another programme, press the
or
button to select another programme line, then
press the ENTER button.
Repeat steps 4 to 6 to set the second programme.
Press the TIMER REC buttons. The TIMER
REC indicator will light. The Timer is
programmed, when the programmed time is
reached, the recording is automatically started.
To cancel timer recording, press the buttons again and
TIMER REC indicator will go out.
NOTE:
•
The VTR section cannot be used while the TIMER REC indicator is lit. If you want to use the VTR
operation, press the TIMER REC buttons to deactivate the timer.
•
After a power failure or disconnection of the power plug, all programmed recording setting and time display
will be lost upon resumption of power if the failure is longer than 30 minutes. In this case, reset the clock
(see page 11) and reprogramme any timer recordings.
•
If you want to correct the digits while setting, press the
button until the item you want to
correct, then press the
or
button to correct the desired setting.
7
6
EXIT
SET
SELECT
: MENU
:
OK : ENTER
:
TIMER REC SET
DATE
START
END
CH
SPEED
23 SAT
3
LP
PDC
OFF
13 : 00
14 : 30
Press the or button to select PDC ON or
OFF. When you have finished setting all your
recordings, press ENTER.
7
4
6
6
5
PDC stands for Programme Delivery Control system. A PDC signal is broadcast at the beginning and end of most
TV programmes. This lets your unit know if a TV programme is running early or late.
PDC is default OFF on this unit. If you switch PDC ON then a recording will not start until your unit receives the PDC
signal. Without PDC your recording would have started and ended as programmed time.
EXIT
SELECT
: MENU
/ ENTER
:
23 SAT
13 : 00 14 : 30
LP
3
:
:
:
:
:
:
:
:
:
:
:
:
:
:
5G00101A[E] P26-37
26/03/2003, 15:00
31
