INSTALLATION
Installation
Before installing the machine, the location characterized
as follows shall be selected:
1.Rigid, dry, and level surface
2.Avoid direct sunlight
3.Sufficient ventilation
4.Room temperature is above 0C
5.Keep far away from the heat resources such as coal or gas.
°
Unpacking the washing machine
1. Remove the cardboard box and styrofoam packing.
2. Lift the washing machine and remove the base packing.Make sure the small triangle
foam is removed with the bottom one together. If not, lay the unit down with side
surface, then remove the small foam from the unit bottom manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
Please take the following steps to remove the bolts:
1.Loosen 4 bolts with spanner and then remove them.
2.Cover the hole with transport hole plugs.
3.Keep the transport bolts properly for future use.
Remove transport bolts
•
Stability is important to prevent the product from
wandering!
•
Make sure that the product should not stand on
the power cord.
Warning!
•
Packaging material (e.g. Films, Styrofoam) can be
dangerous for children.
•
There
is
a
risk
of
suffocation
!
Keep all packaging
well away from children.
Warning!
•
You must remove the transport bolts from the backside before using the product.
•
You’ll need the transport bolts again if you move the product , so make sure
you keep them in a safe place.
Warning!
w
w
W
20mm
>
Installation area
11
