TDP-MT8 Service Guide
33
Remove and Replace the Inner Handle and Front Vent
Located inside of the outer handle and forward of the
front vent
, the
inner handle
provides a hand
surface and structural rigidity for the handle.
1.
Remove the following items:
Outer handle (see page 41)
Rear bezel (see page 51)
Top case (see page 57)
Front IR receiver (see page 31)
2.
Lift the inner handle from the side of the projector opposite the lens. Swing the handle upward
slightly then lift it from the bottom case.
3.
Separate the front vent from the inner handle by using a small flat blade screwdriver to disengage
the tab on the front vent from the slot on the inner handle.
NOTE
You don't need to separate the front vent from the inner handle if you're removing the inner
handle to access other FRUs in the projector.
4.
Use the small flat blade screwdriver to disengage the tab on the opposite side of the front vent
from the slot on the inner handle.
Содержание TDP-MT8
