10
SLIDE SWITCH
• Do not change setting of the slide switch because a malfunction occurs by other settings.
• Before usage, check the slide switch is set to the position as follows;
HOW TO INSERT THE BATTERIES
1. Holding the both sides of the cover and remove it by sliding downward.
2. Correctly insert 2 AAA alkali batteries ma and - polarities with indications.
3. Push RESET button with something tipped and attach the cover.
• Replace the batteries when the display section of the remote controller is difficult to be read,
or when the signal cannot be sent if you are not close to the sensor.
(The standard replacement time of the alkali batteries is approx. one year.)
• Use the same type of new batteries for replacing two batteries.
• In case when you do not the remote controller
for a long time, remove the batteries.
RESET button
Cover
S K N
A H C
S K N
A H C
Removal of battery cover
Operation mode display
of remote controller
Slide switch position
Swing
Slide switch position
Flashing position
on remote controller
Corresponding model
for change of flap
HIGH
MED.
