8
HOW TO OPERATE THE TIMER
• After setting of the timer, set the remote controller at a position where the signal can reach the
sensors (indoor unit body) .
(The signal of the timer operation is sent from the remote controller.)
• Set up the timer during display of the operation mode.
Use in the following cases
To stop the air conditioner
after the previously set time
has passed
To stop the air conditioner
every time after the previously
set time has passed
To operate the air conditioner
after the previously set time
has passed
During display
Timer time
Every pushing
, the setup time increases by
0.5 hour (30 minutes).
The maximum time to be set is 72.0 hours.
Every pushing
, the setup time decreases by
0.5 hour (30 minutes).
The minimum time to be set is 0.5 hours.
Timer display
Every pushing
SET
, the display changes as
follows;
<Use example>
How to use OFF timer
(Ex.) To stop the unit 30 minutes after
1
When pushing the timer
SET
once,
and the time flash on the remote
controller.
2
Push TIME
or
to set the time
to 0.5.
3
Push
SET
and the
go on timer.
How to use the repeat timer
(Ex.) To stop the air conditioner every time
after 2.5 hours has passed
1
When pushing the timer
SET
twice,
,
and the time flash on the
remote controller.
2
Push TIME
or
to set the time
to 2.5.
3
Push
SET
and the
,
go on
timer.
The
works, and the operation stops
after 2.5 hours. When pushing
(Start/Stop) button again to operate the
unit, the operation stops after 2.5 hours.
How to use ON timer
(Ex.) To operate the unit 8 hours after
1
When pushing the timer
SET
three
times,
and the timer flash on the
remote controller.
2
Push TIME
or
to set the time
to 8.0.
3
Push
SET
The operation mode display disappears,
and then time and the
go on.
To stop the timer operation
To stop the timer operation
Push
C L
button. Then the timer display
disappears.
ADR
No display
