T2150 Series
4-21
Installing the Top Cover, Display assembly, and Speaker
To install the T2150 series top cover, follow the steps below and refer to figures 4-15 to 4-17.
1.
Seat the
top cover
with
display assembly
(figure 4-17).
2.
Connect the
display sensor switch cable
to
PJ11
on the system board (figure
4-17).
3.
Connect the
display cable
to
PJ17
on the system board (figure 4-17).
4.
Begin at the back and snap the
top cover
into place (figure 4-17).
5.
Secure the
two M2.5x8 silver screws
on the top cover (figure 4-16).
6.
Secure the
four flat-head M2.5x6 screws
on the battery pack cover (figure 4-16).
7.
Connect the
AccuPoint cable
to
PJ13
on the system board and press in on the
hinge on each side to secure the palm rest (figure 4-16).
8.
Close the display and turn the computer over so the back faces you.
9.
Secure the
three M2.5x8 silver screws
on the bottom of the computer (figure
4-15).
10.
Install the hard disk drive, keyboard, optional memory module, optional PCMCIA
card, and battery pack as described in sections 4.6 back through 4.2.
Содержание T2150 series
