Toshiba STORE alu, Руководство пользователя

Страница: 17 / 398

17
Vertical Placement
Most likely, your Drive was packaged with the stand attached
to the Drive case, so you can place the Drive on your desktop
vertically right out of the box. However, if the stand was not
already attached, follow the steps below:
1. If the screws and nuts are not already affixed to the stand, insert
the two screws through the two holes from the underside of the
stand. Screw a nut onto the end of each screw just far enough to
hold the nut to the screw. Do not tighten the nuts.
2. With both screws and nuts in place, push down on each screw
head to make sure the screws extend through the holes as far as
they will go.
3. Attach the stand to the Drive case by sliding the nuts through
the groove in the Drive case, entering from the backside of the case.
You cannot slide the stand in from the front of the case. The stand
is symmetrical so it does
not matter which end you
insert first. Once the nuts
are in the groove, position
the stand so that it is cen-
tered with the Drive case.
4. While holding the stand in place with one hand, use a screwdriver
with the proper type and size head to tighten the screws. Make sure
the stand is firmly secured to the Drive case.