EN-4
General Guide
Replacing Remote Controller Batteries
Open the battery cover on the back of the remote controller, replace the old batteries with new ones, and
then close the battery cover.
Important!
Important!
Important!
z
To avoid running down the batteries, store the remote control unit so its buttons are not
pressed inadvertently.
You can use the projector to project an image of analog RGB output from a computer.
Important!
Important!
Important!
z
Always turn off the projector and the computer before connecting them.
z
Take care so the volume level of the computer is not set too high.
1.
Open the battery cover on the back of
the remote controller.
2.
Load two new batteries into the case,
making sure that their positive (+) and
negative (–) ends are facing correctly.
3.
Close the battery cover on the back of the remote controller.
Connecting a Computer to the Projector
<Projector>
<Computer>
Bundled mini D-Sub cable
Audio cable (commercially available)
AV terminal
To monitor terminal
(analog RGB output terminal)
COMPUTER terminal
To line output terminal
SHX10_V_QSG_TSP.book Page 4 Friday, September 9, 2011 1:38 PM