Toshiba SD-24VBSB, Руководство пользователя

Страница: 36 / 41

1-41
Cause
z
The power cord is disconnected
z
DVD or VCR button is not switched
properly.
z
No disc is inserted.
z
No tape is inserted.
z
The TV is not set to receive DVD+VCR
signal output.
z
The video cable is not connected
securely.
z
The Progressive Scan is set to On on
the setup menu but is connected to a
standard(analog) television.
z
The equipment connected with the
audio cable is not set to receive
DVD+VCR signal output.
z
The audio cables are not connected
securely.
z
The power of the equipment connected
with the audio cable is turned off.
z
The Digital Audio Output is set to the
wrong position.
z
The disc is dirty.
z
The TV channels are not tuned in properly
z
Tape heads are dirty.
z
Tape is a rental or was recorded on
another VCR.
z
This unit can only output 625p
Progressive scan picture.
z
An unplayable disc is inserted.
z
The disc is placed upside down.
z
The disc is not placed within the guide.
z
The disc is dirty.
z
The Rating level is set.
z
Is the cassette compartment empty?
z
Audio mode is not set properly.
z
NICAM mode is not set properly.
Correction
z
Plug the power cord into the wall outlet
securely.
z
Refer to page 6.
z
Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
z
Select the appropriate video input mode
on the TV so the picture from the
DVD+VCR player appears on the TV
screen.
z
Connect the video cable into the jacks
securely.
z
Set Progressive Scan to Off
(see page 19).
z
Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD+VCR player.
z
Connect the audio cable into the jacks
securely.
z
Turn on the equipment connected with
the audio cable.
z
Set the Digital Audio Output to the
correct position, then turn on the
DVD+VCR player again by pressing
++/ /1 1 .
z
Clean the disc.
z
Check tuning, carry out tuning again.
z
Clean video heads.
z
Use PR/TRK (+/-) for manual tracking
adjustment while tape is playing.
z
Make sure that your TV can support
625p Progressive scan picture or set
Progressive scan to off.
z
Insert a playable disc. (Check the disc
type and Regional code.)
z
Place the disc with the playback side
down.
z
Place the disc on the disc tray correctly
inside the guide.
z
Clean the disc.
z
Cancel the Rating function or change
the rating level.
z
Eject the tape in.
z
Select STEREO by repeatedly pressing
AUDIO on the remote control.
z
Make sure NICAM in the menu is set to
AUTO for the station to be recorded.
Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Symptom
No power.
The power is on, but
the DVD+VCR player
does not work.
No picture.
No sound.
The playback picture is
poor.
The DVD+VCR player
does not start playback.
Video tape cannot be
inserted.
No Hi-Fi sound
No NICAM sound
recording