5. Operation in Top View Mode
5-4
5.4 Performing jog run
When Panel Jog Run is selected (parameter F262=1, CMOd=1), “JOG” is displayed in
the lower right corner of the window. When “JOG” is displayed, jog run can be
performed using the [F4] key.
The switching to jog run cannot be performed during operation. When switching to Jog
Run mode, operation has to be stopped temporarily.
1
Press the [F4] key to carry out jog run.
The jog run frequency is displayed on the screen.
(In this example, the operation frequency is set at
5.0Hz.)
Operation continues as long as the [F4] key is
pressed, and it stops when the [F4] key is
released.
Functions of function keys
[F1] key: Switches between Quick mode and
Standard Setting mode.
[F2] key: Brings you to the Language selection
window.
[F4] key: Executes a jog run command.
5.5 Emergency stop/reset operation
To make an emergency stop or to reset the inverter, follow these steps. An emergency
stop can be made when operation is performed with the terminal board (parameter
CMOd=0, 2, 3 or 4).
1
Press the [STOP/RESET] key, which displays
the blinking code “EOFF” in the upper right
corner of the window.
2
Then press the [STOP/RESET] key again.
The Emergency Stop window appears and the
blinking code “E” is displayed.
Top View Mode
EOFF
Fwd 60.0 Hz
RUN
60.0
Hz
Emargency stop?
Lng
Quick
---
Top View Mode
Fwd 60.0 Hz
Trip
E
Emargency stop
Lng
Quick
---
Top View Mode
Fwd 35.0 Hz
JOG
5.0
Hz
Lng
Quick
JOG
“JOG” is
displayed.
