Toshiba REGZA XV Digital Series, Руководство пользователя

Страница: 54 / 59

A
Make sure that the cables used have the HDMI logo
on them ( ).
Some early HDMI equipment may not work properly with
the latest HDMI television products, due to new standard
adoption. Try setting
Lip Sync , INSTAPORT™ and RGB
Range to Off .
Why is there no sound or picture when in
HDMI mode?
Q
Below are the answers to some of the most common queries.
For more information go to
www.toshiba.co.uk
A
Check all lead connections.
Check the volume has not been turned down or that
sound mute has not been selected.
Why is there a picture but no sound?
Q
A
Check that Panel lock is not On .
Why don’t the controls on the front of the
television work?
Q
A
Make sure the media player is connected to the
television as shown on page 7, then select the
correct input by pressing
B
.
Why doesn’t the media being played show
on screen?
Q
A
Check the correct input has been chosen, S-VIDEO
or AV . See AV connections page 50.
Why is the media picture in black and
white?
Q
A
When using an external source, for instance, a
poor quality video tape, if there is little or no colour,
improvements may sometimes be achieved. The colour is
factory set to
Auto. to automatically display the best
colour system. To check that you have the best colour:
There is a picture, but why is there little or
no colour?
Q
With the external source playing, select Manual
Settings from the SETUP menu .
With
f
or
e
choose between Auto, PAL,
SECAM, NTSC 4. 43 or 3. 58 .
1
2
Questions and Answers
54
Select the ATV Manual Tuning menu. Highlight
the station and press OK , then press
x
to select
Manual Fine Tuning .
Using
f
or
e
adjust to get the best picture and
sound. Press OK and then EXIT .
1
2
A
Interference or a weak signal. Try a different
television station.
Manual Fine Tuning may help.
What else can cause a poor analogue
picture?
Q
A
Remove it by pressing .
Why is there a message permanently on
the screen?
Q
i
+
A
Another mode is selected. Press
B
to select DTV .
Why is DTV unavailable?
Q
A
If the RED LED is unlit check that the mains plug is
connected to the power supply and press the
i
/
I
POWER button on the left side of the television. Then
press
i
on the remote control, it may take a few
moments, the GREEN LED will be lit.
Why is there no sound or picture?
Q
A
Check the batteries aren’t discharged completely or
inserted incorrectly.
Why doesn’t the remote control work?
Q
A
Check whether the
u
button was pressed while
recording was in progress.
Why did the picture stop while recording
via scart?
Q