6
HOW TO USE REMOTE CONTROLLER
■
Cooling/heating/fan only operation
Start
SWING
FAN
4
3
1
2
1
START/STOP button (
)
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool
, Heat
, or Fan only
.
3
Temperature button (
)
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4
Fan speed button (FAN)
Select one of
LOW , LOW
+
,
MED
, MED
+
, HIGH
.
• The
OPERATION lamp on the display panel of
the indoor unit goes on. And operation starts after
approximately 3 minutes. (If you select FAN ONLY
mode, the unit will start immediately.)
• The
: Fan only mode does not control temperature.
• Fan speed
is the same as
HIGH
.
Therefore, perform only steps
1
,
2
and
4
to select
this mode.
Stop
START/STOP button (
)
Press this button again to stop the air conditioner.
NOTE
When the indoor unit is operated together with a cooling
only outdoor model outdoor unit,
appears on the
remote controller but the heating operation is disabled.
■
Dry operation
Start
SWING
FAN
3
1
2
1
START/STOP button (
)
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Dry .
3
Temperature button (
)
Set the desired temperature.
• The fan speed display indicates
.
• The
OPERATION lamp on the display panel
of the indoor unit lights, and operation starts after
approximately 3 minutes.
Stop
START/STOP button (
)
Press this button again to stop the air conditioner.
Owner’s Manual
- 8 -
8-EN