2
9
8°C
OPERATION
1. Press
button to change to 8°C set temperature
heating operation.
2. Press
to adjust setting temperature from 5°C to
13°C.
Note:
8°C will operate in Heating mode only. If Air conditioner
performs in cooling operation (including automatic
cooling) or dry operation it will change to heating
operating.
10
COMFORT SLEEP OPERATION
For comfortable sleep, automatically control air fl ow and
automatically turn OFF (Except in DRY mode and Fan only
mode).
1. Press
: Select 1, 3, 5 or 9 hrs for OFF timer
operation.
2. Press
to cancel the comfort sleep operation.
Note:
The cooling operation, the set temperature will increase
automatically 1 degree/hour for 2 hours (maximum
2 degrees increase). For heating operation, the set
temperature will decrease.
8
PRESET
OPERATION
Set your preferred operation for future use. The setting will
be memorized by the unit for future operation (except airfl ow
direction).
1. Select your preferred operation.
2. Press and hold
until stop blinking and the
P
mark displays.
3. Press
: Operate the preset operation.
11
FILTER
RESET
Firstly, turn off the circuit breaker.
FILTER lamp lights on; the fi lter must be cleaned.
To turn off the lamp, press RESET button on the indoor unit for
Hi-wall or ON/OFF button for Bi-fl ow console, also can push the
FILTER button on the remote control in another way. (Please
follow the instructions in the air conditioner owner’s manual.)
12
REMOTE CONTROL A-B
SELECTION
To separate using of remote control for each indoor unit in case
of 2 air conditioners are installed nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn the air
conditioner ON for Hi-wall type or press and hold MODE
button on the indoor unit more than 20 seconds for Bi-fl ow
console type. (Please follow the instructions in the air
conditioner owner’s manual.)
2. Point the remote control at the air conditioner.
3. Push and hold
button on the Remote Control by the
tip of the pencil. “00” will be shown on the display.
4. Press
during pushing
. “B” will show on the
display and “00” will disappear and the air conditioner will
turn OFF. The Remote Control B is memorized.
Note:
1. Repeat above step to
reset Remote Control
to be A.
2. Remote Control A has
not “A” display.
3. Default setting of Remote
Control from factory is A.
13
POWER-SELECTION OPERATION
This function is used when its circuit breaker is shared with
other electrical appliances. It limits the maximum current/power
consumption to 100%, 75% or 50%. The lower the percentage,
the higher the saving and also the longer the compressor
lifetime.
Press
: Select:
(for 100%),
(for 75%),
(for 50%)
• When the level is selected, PWR-SEL level fl ashes on
LCD display for 3 seconds. In case of 75% and 50% level,
number “75” or “50” also fl ashes for 2 seconds.
• Due to the reason that POWER SELECT FUNCTION limits
the maximum current, inadequate capacity may occur.
1112150109_01_EN.indb 2
2/11/58 BE 3:39 PM
