CAUTION
• The FIX and SWING buttons will be disabled
when the air conditioner is not in operation
(including when the ON timer is set).
• Do not operate the air conditioner for long hours
with the air
fl
ow direction set downward during the
cooling or dry operation.
Otherwise, condensation may occur on the
surface of the vertical air
fl
ow louver and cause
dew dripping.
• Do not move the vertical air
fl
ow louver manually.
Always use the FIX button. If you move the
louver manually, it may malfunction during
operation.
If the louver malfunctions, stop the air conditioner
once, and restart.
• When the air conditioner is started immediately
after it was stopped, the vertical air
fl
ow louver
might not move for 10 seconds or so.
• Louver operation is limited when performing
group control. (see page 27)
■
Adjust the horizontal air
fl
ow
Preparation
• Take hold of the lever on the horizontal air
fl
ow
louver and move them to adjust the air
fl
ow
direction as required.
• You can adjust the air
fl
ow at the left, and right
locations of the louver.
■
Wireless remote controller A-B
selection
To separate using of remote control for each indoor
unit in case of 2 air conditioners are installed
nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit
to turn the air conditioner ON.
2. Point the remote control at the indoor
unit.
3. Push and hold
button on the Remote
Control by the tip of the pencil. “00” will
be shown on the display. (Picture
1
)
4. Press
during pushing
“B” will
show on the display and “00” will
disappear and the air conditioner will turn
OFF. The Remote Control B is
memorized. (Picture
2
)
Note:
1. Repeat above step to reset Remote
Control to be A.
2. Remote Contrl A has not “A” display.
3. Default setting of Remote Control from
factory is A.
1
2
Owner’s Manual
- 23 -
23-EN
OM_1121250216_EN_FR_ES.indb 23
OM_1121250216_EN_FR_ES.indb 23
8/4/2565 BE 13:24
8/4/2565 BE 13:24
