218
Keeping Your Files Safe
Using passwords in the Windows® operating system
5.375 x 8.375 ver 2.3
To register a user only password in System Setup:
1
Click Start, then click Shutdown, and click OK.
The computer shuts down.
2
Hold down the
Esc
key and press and hold the power
switch until the on/off light on the system indicator panel
illuminates (green) for approximately one second. When
the following message appears on the screen: “Check
system, Then press [F1] key,” press
F1
.
The System Setup screen appears.
3
Press
H
to move to the HDD PASSWORD section on the
screen.
4
Press the spacebar to select User Only password mode.
5
Press the down arrow key to move to the User Password
section.
6
Press the spacebar, then type a password of 1 to 16
characters and press
Enter
. You may use any combination
of letters and numbers in your password.
7
When System Setup prompts you to verify the password,
type it again and press
Enter
.
If the two passwords match, System Setup displays:
Registered
. If the two passwords do not match, an error
message appears. Repeat steps 6 and 7 to enter the
password again.
8
Press
End
to save the change.
9
When System Setup prompts you to confirm your
change, Press
Y
.
