Toshiba nv-pack Series, Инструкция по эксплуатации

Страница: 25 / 95

Chapter 3 Setting
6F8C1621
12
3.1 Switch Setting
The switches that determine the operation mode and station address are on
the front panel of the JTNI.
The method to set the switches is shown below.
Important
•
Set the switches that determine the operation mode and station address of the JTNI before
turning the power on.
3.1.1 Station address setting switch (STN-H, STN-L)
The station address setting switches are hexadecimal rotary switches that
determines the station address on the TC-net 100 network.
For setting of the IP address, refer to "3.2 Network parameter setting." Set
the station address (1 to 254) that has been assigned upon system
configuration in a HEX code. Assign an address with a different value to each
of the nodes in the system.
Table 3-1 shows the setting of a station address.
Table 3-1 Station address setting
Name Description
Setting range : 01 to FE(h)
STN-H STN-H(upper digit address): 0 to F(h)
STN-L STN-L(lower digit address): 0 to F(h)
(Note) (h) indicates hexadecimal.
Remark
•
For setting, use a small slotted screwdriver.
Set the station address in hexadecimal.
For example, if the address value is 28, it is ‘1C’ (h) when converted to
hexadecimal. Therefore, set as follows:
STN-H side: ‘1’
STN-L side: ‘C’
For decimal-hexadecimal conversion, refer to "Appendix D
Decimal-hexadecimal conversion table."
Note
•
Be careful so that the address does not overlap with other nodes.