DISASSEMBLY INSTRUCTIONS
B1-3
1-9: DVD MT PCB/DVD DECK (Refer to Fig. 1-9)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Short circuit the position shown in Fig. 1-9 using a
soldering iron. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
Remove the 5 screws
1
.
Remove the DVD Top in the direction of arrow (A).
Remove the 4 screws
2
.
Remove the DVD Deck in the direction of arrow (B).
Disconnect the following connectors:
(CP2301, CP2302 and CP2303).
Remove the 2 screws
3
.
Remove the DVD MT PCB in the direction of arrow (C).
Remove the screw
4
.
Remove the 3 screws
5
.
Remove the Deck Angle in the direction of arrow (D).
NOTE
Before your operation, please read “PREPARATION OF
SERVICING”.
Use the Lead Free solder.
Manual soldering conditions
• Soldering temperature: 350
±
5˚C
• Soldering time: Within 2 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
When Soldering/Removing of solder, use the drawing
equipment over the Pick Up Unit to keep the Flux smoke
away from it.
When installing the DVD Deck, remove all the soldering on
the short circuit position after the connection of Pick Up
PCB and DVD MT PCB connector.
1.
2.
3.
4.
5.
Fig. 1-9
Short circuit using a
soldering iron.
Pick Up PCB
(A)
(B)
DVD Deck
(C)
(D)
DVD MT PCB
CP2301
CP2302
CP2303
3
4
1
DVD Top
1
1
2
1
2
2
2
3
5
5
5
Deck Angle
1-10: POWER PCB (Refer to Fig. 1-10)
1.
2.
3.
Remove the 3 screws
1
.
Disconnect the following connectors:
(CP1707 and CP1710).
Remove the POWER PCB in the direction of arrow.
Fig. 1-10
Power PCB
CP1707
CP1710
1
1
1
1
