Owner’s Manual
– 12 –
EN
* F1 appears in the CODE No. section on the
remote controller. This indicates that the louver 01
shown in the following figure is selected.
NOTE
Even in louver lock mode, the louver temporarily moves
in the following cases:
• When the air conditioner is stopped
• When heating starts
• When defrosting
• When thermo. off.
Releasing the louver lock
Set “0000” in Step 4 of “Setting the louver lock”.
The
mark disappears.
* Steps 1 - 3 and 5, 6 of “Setting
the louver lock” also apply to
releasing the lock.
Adjusting the horizontal direction
1
Push and hold the
and “TEMP.
”
buttons for at least 4 seconds while running is
stopped.
blinks.
“01” appears in CODE No.
2
Push the
button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
The fan of the selected unit runs, and the louver
swings.
3
Push the “TEMP.
” buttons to change
the CODE No. to “45”.
4
Push the “TIME
”buttons to select a
direction.
5
Push the
button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push the
button to finish the setting.
* If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
Louver No.
0001 - 0005
(Louver position
code)
Electrical control box
Refrigerant
pipe
Drain pipe
0000
SET DATA
Direction SET
DATA
Direction setting
“0000”
Smudging reduction position
(reduces ceiling smudging)
(factory default)
“0002”
Cold draft position
(Less directly expose your body to
cool air)
UNIT LOUVER
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
No
display
4-way cassette type
When cooling
Point the louver horizontally.
When heating
Point the louver downward.
• The louver automatically closes when running is
stopped.
• In pre-heating mode, the louver points upward. The
swing indication appears on the remote controller
even in pre-heating mode, but the actual swing starts
only after pre-heating is complete.
2-way and 3-way air discharge
The air discharge can be changed to the 2-way or 3-way
type to suit your room shape and style.
For details, contact the dealer where you purchased the
air conditioner.
2-way cassette type
When cooling
Point the louver horizontally to send cool air across the
entire room.
When heating
Point the louver downward to send heated air to the floor.
1-way cassette type (SH series)
When cooling
Point the louver horizontally to send cool air across the
entire room.
When heating
Point the louver downward to send heated air to the floor.
• The louver automatically closes when running is
stopped.
• In pre-heating mode, the louver points upward. The
swing indication appears on the remote controller
even in pre-heating mode, but the actual swing starts
only after pre-heating is complete.
EN-23
EN-24
1FAN_OM_EHV0000101-01.book Page 12 Thursday, September 13, 2018 5:10 PM
